Painting Home Exterior
• Cover nearby plants with drop cloths or tarps.
• Turn off any A/C units and cover with plastic and tape as needed.
• Inspect your siding and trim carefully, looking for holes and cracks, then make any necessary repairs.
• Fill any holes with wood filler, and then sand smooth after drying.
• You can remove the old putty with a chisel or putty knife, but be careful not to break the glass.
• Apply new glazing compound as needed, pressing it into place with a putty knife.
• Using a wire brush or broom, apply either TSP solution or a TSP substitute cleaner.
• Use a pressure washer to speed up the process, but be careful not to force water into any cracks between the siding planks. Be sure to wear gloves and safety glasses when using cleaners and chemicals.
• Only remove existing paint if it is loose or flaking. If your home was built prior to 1978, be sure to follow proper safety and contaminated procedures for lead paint.
• Rinse until the runoff water is clear.
• If you used a TSP solution to clean the house, rinse twice to ensure the solution is completely gone.
• Let the siding and trim dry completely, usually two days, before painting.
• You’ll also want to prime surfaces if glossy paint is to be top-coated.
• Cedar and redwood contain less resin that bleeds through water-based paints, so use oil-based primer on woods.
• Make sure the surface you are painting is dry and there is no rain in the weather forecast.
• Apply primer to bare siding. For best results, allow primer to dry.
Paint roof trim and soffits before the walls if they are a different color.
Use a corner roller or trim brush to paint these areas.
On clapboard or shingle siding, cut in the lip (bottom edges) of the siding before painting the face.
• Work as far away as you can reach.
• Finish the stroke directly in front of you. Repeat until the block of siding you can reach is painted.
Feathering means placing the surface of the brush or roller against the siding gradually, instead of abruptly. This eliminates a definite start line and makes it easier to blend the next block of strokes into the present block.
• Work quickly as it is important to blend the new stroke with the old while the paint is still wet to avoid overlapping marks. Never stop in the middle of a section.
• Paint the corner of the house so the paint color is consistent. Move the ladder so you can reach the completed block of siding.
• To eliminate overlap marks, rewet the feathered edges of the previously painted block with your brush or roller just before you start each new stroke.
• Repeat the process until the top area is completed and then finish the lower sections.
• Choose a calm day to paint as a windy day can make spraying difficult.
Share this Post
As a customer, you are our number one priority at Verizon. Our goal, every day, is to make sure that you receive the best…Read More